Solutions

Press-Line Systems

Complete robot-linked press lines — engineering, tooling, simulation, build and commissioning from one supplier.

Press-Line Systems

A press line is only as fast as the handling between its presses. Bilsing Automation builds that handling as a complete system: robots, crossbars, grippers, destacking and racking, engineered together and commissioned as one line rather than assembled from parts that were never meant to meet.

We link presses with robot-based automation instead of conventional mechanical feeders. That choice keeps a line flexible — the same cell can be re-tooled for a different part rather than rebuilt — and it puts the cadence in software, where it can be tuned.

What a system includes

We take responsibility for the whole handling scope. Front of line, that means robot destackers working from the blank stack — vision-guided where the stack demands it — plus blank loading and centring. Between presses it means crossbars, transfer beams and coupling systems. At end of line it means automatic racking, and the carts and nests that keep tooling ordered between runs.

Every line is proven before it is built. Full-line 3D simulation validates reach, cycle time and parts per minute, and clears collisions while changes still cost nothing. One drawing set, one contact, one party accountable for the cadence you were promised.

Quoted lines typically simulate at ten to sixteen parts per minute depending on the part family, and the ramp-up to that cadence is part of the scope rather than something you chase afterwards.

COBRA — one of the platforms we build on

Where a line needs crossbar transfer, we most often build it on COBRA. It is integrated into the robot's own kinematics rather than bolted onto a wrist, so the controller plans the crossbar as one more joint and the line calls up peak performance anywhere in the motion profile without overloading a component.

The platform carries a 1,750 mm linear stroke, an optional tilt axis of ±30° and an optional shifting axis of ±150 mm — enough for tool guides, inclined dies and deep-drawn parts a fixed beam cannot reach. Where a line is better served by linear transfer, tri-axis or a dedicated cell, we build that instead.

New lines and retrofits alike

The same system suits a greenfield servo line and a press line that has been running for twenty years. In a retrofit we replace ageing robots or mechanical feeders, rework foundations and control cabinets, and hand the line back faster than it could be rebuilt — usually with a higher stroke rate than it ever achieved. Because the work happens on a plant that still has to produce, the schedule is planned around your shutdown, not ours.

Systems are delivered through Bilsing Automation in Germany, France and North America, with engineers who speak the language of your plant. Send us the part, the press and the cadence you need, and we will come back with a line concept.